货号 18443
GTIN (EAN-Code): 4006209184431
fischer wall holder SPH 30
Top Features
- Pi-shaped wall holder for high loads.
- Use as sliding point.
- Easy installation due to pre-drilled holes.
优点/产品说明
Wall holder as sliding point
Advantages
- The wall holder is used to absorb and transfer the loads applied to the façade system.
- They compensate the tolerance of the substrate.
- Available as fixed and sliding point anchors.
- Absorption of thermal longitudinal expansion through slots on the sliding point anchor.
The Pi-wall holder of the subframe system ATK SystemOne made of aluminum is the basis for a façade subframe. It is fastened to the building substrate using fischer fixings. To reduce thermal bridges, thermostops made of hard-PVC can be attached to back of the wall holders. In order to enable all common insulation thicknesses and façade offsets, the wall holders are designed and manufactured in different projection lengths. To allow the thermal expansion of the profiles, the wall holders are used both as fixed and sliding points. The fixed point absorbs the entire dead loads of the façade panels and subframe system in addition to the proportional wind loads.
Properties
- Aluminum (e. g. EN AW 6063, 6061)
应用和认证
Applications
- As a wall holder for subframe systems in rainscreen facades
Building materials
- All building substrates
安装说明
Functionality
- Vertical load transfer from the subframe system into the building substrate
- Absorption of higher loads through double-sided attachment
- Compensation for structural tolerances
- Easy installations with attachments on both sides
Installation FPH AL
1 / 4
- 1
- 2
- 3
- 4
技术数据
| Length ( L ) | 30 mm |
| Width ( W ) | 140 mm |
| Width ( W2 ) | 50 mm |
| Height ( H ) | 60 mm |
| Thickness ( T ) | 2,5 mm |
| Dimensions ( d ) | 11x25 mm |
| Hole pattern | 2x 11x25 mm |
| Hole pattern profile | 2x 5.1x15 mm |
| Angle | 90 ° |
| System | — |
| Amount | 100 pcs |
| GTIN (EAN-Code) | 4006209184431 |
| BWM | 18443 |