PowerFull II CHTF BC

Product Variant

Approvals / Test reports

33 product variants

Diameter

Length

Drive

Thread length

Packaging

Amount

GTIN (EAN-Code)

Legend = Permission Available— = Permission not Available

Viewed 18 of 33 variant (s)

Advantages

The unique core milling geometry makes low axial and edge distances as well as high loads possible.
The innovative tip geometry ensures that screws are driven fast and reduces splintering of the substrate. The needle point makes the screw easy to place e.g. for angled screw connections even in extreme situations.
The cylindrical head with additional milling pockets ensures clean countersinking of the head. This can be countersunk deep into the wood using a long bit.
The new screw geometry significantly improves the pull-out load capacity and optimises the screw-in torque.

Applications

Building materials

Solid hardwood of material strength classes C14 - C40 in accordance with EN 338 / EN 14081-1
New: Solid beech, ash or oak in accordance with EN 338 / EN 14081-1, with pre-drilling
Glued-laminated timber of at least material strength class GL24c in accordance with EN 1194 / EN 14080
New: Glued-laminated timber made of beech, ash or oak according to European Technical Approval or the national regulations applicable at the installation site, with pre-drilling
Laminated veneer lumber LVL in accordance with EN 14374
Glued-solid timber Duo and Trio beams in accordance with EN 14080 or the national regulations applicable at the installation site
Cross-laminated timber according to European Technical Approval or the national regulations applicable at the installation site
Construction beech in line with approval Z-9.1-838 and Z-9.1-837 and FST according to ETA-14/0354, with pre-drilling

You can find detailed information on building materials in the approval document.

Approval